Making Buildings Blast-Proof Through Carbon FRP Retrofit
 

Blast Protection with Carbon Fiber Reinforced Polymer (CFRP)

Buildings and Walls can be blast protected by using Carbon FRP from QuakeWrap™

SmokestackQuakeWrap™ provides an effective Carbon Fiber Reinforced Polymer (CFRP) system for blast protection of buildings. Tests have clearly demonstrated the effectiveness of QuakeWrap™ in resisting extreme pressures caused during a blast explosion.

Tests were conducted on two identical unreinforced masonry block walls. One of the walls was retrofitted by applying QuakeWrap™ fabric to both sides of the wall; the other wall remained unretrofitted as a control specimen.

Loading was simulated by 200 pounds of equivalent TNT placed at a height of 3 feet and a distance of 30 feet away from the walls. This resulted in a pressure of 200 psi (pounds per square inch) on the walls. For comparison, this is 720 times more load than the 40 psf (pounds per square foot) load that is used for the design of a typical floor system in a building.

The wall deflected 9 inches but remained fully intact even though the block units inside the wall crushed in compression (as expected according to the design of the wall). Because of the construction of the wall that included narrow gaps along the vertical edges, some of the blast wave pressure penetrated inside the room. Nevertheless, that pressure inside the room was only about 4.2 psi. Ear drum damage and lung collapse usually occur at 5 and 10 psi, respectively. Thus, it is clear that the occupants of the room retrofitted with QuakeWrap™ would have survived the blast.

PUBLICATIONS:

Below are some articles related to blast retrofit of buildings:

  • Fort Bragg Barracks Receives Pioneering Force Protection Retrofit (for Blast Loading) By Erin Barstow, Public Works Digest, May/June 2009, 28
  • Blast Loading Retrofit of Unreinforced Masonry Walls By Mo Ehsani, and Carlos Pena, Structure Magazine, April 2009, 16-19